The installation method of the sealing strip The installation method of the sealing strip of the car is very simple, that is, the glue strip on the sealing strip can be pasted on the door.

Specific steps are as follows:

1. Wipe the sticking part clean;

2. Tear off the adhesive film of the sealing strip;

3. Paste the sealing strip to the installation site along the inner frame of the car;

4. Cut off the excess tape with scissors.

Note: When pasting, make sure that the surrounding environment is dry and dust-free. If the climate temperature is lower than 10°C, it is best to use the hot air of a hair dryer to heat the vehicle installation part and the adhesive part of the sealing strip before pasting it. At the same time, use the hot air of the hair dryer to heat it again after pasting it, and press it properly with your hands to ensure that it is firmly adhered; in order to ensure the reliability of later use, the sealing strip should be avoided rain and sun exposure within three days after it is installed.

When installing the car seal, tools are required, and it cannot be installed without tools. The installation method:

1. First stick the three-piece adhesive strip on the glass. There is now an opening in both the glass and the strip, in the metal sheet of the cab;

2. It is necessary to pass through the gap between the three ports. Wearing it is to integrate the three-port sealing strip and the glass cab into one. If you need to put the three ports in, you will need tools;

3. Some shops that sell tools have them. The appearance of the tool is that the tool head is curved and there is a hole in the curved part. It is enough to put the three-hole core into it and clamp the three-hole core and push it hard to install it.