Installation method of automobile sealing strip
Before installing the bai glass, the vehicle doors and windows should be carefully removed from the notches, such as mortar, brick chips, wood blocks, etc., and the glass should be carefully aligned to ensure that the gap on both sides is uniform, and timely corrected and fixed to prevent collision and displacement , Deviate from the center of the notch. The rubber sealing strip cannot be pulled too tightly, and the blanking length is 20-30mm longer than the assembly length.
The mounting should be in place when installing, the surface should be straight, and it should be in close contact with the glass and the glass notch, so that the force around the glass is even. At the corners, the rubber strips should be cut off with a bevel, and glue should be injected at the break to be firmly bonded. When sealing the glass with sealant, you should squeeze the glass with a rubber strip or a rubber block to leave a gap for the glue. The depth of the glue should not be less than 5mm. Before the glue is cured, the glass should be kept from vibration.
Sealing of the front, rear and side edges of the vehicle: prop up the hood, and paste the front, rear and side edges of the hood and the car body to effectively seal the gap between the hood and the car body. When the vehicle is running, it can accelerate the passage of air through the air intake grille and improve the heat dissipation performance. At the same time, it can reduce the friction between the hood and the front part, left and right front fenders, and reduce the noise caused by bumps and friction. If the gap is large, you can paste two layers.
By sealing the gaps between the four doors and the car body, the sealing performance of the vehicle can be effectively improved and wind noise can be reduced. The improvement of sealing performance can also prevent sand, dust and rain from entering the cockpit, and improve the cooling efficiency of air conditioning. Carefully apply special glue on the inside of the door, and apply special glue on the side of the cut sealing strip, and then stick the sealing strip along the inner side of the door.