Automobile sealing strip is one of the primary parts of automobiles. It is widely used in doors, windows, bodies, seats, sunroofs and trunks. It can be used for rubber hinges of passenger car luggage compartment doors. It also has special waterproof, Sealing and other functions.

Car Sealing Strip Usual Protection and Use Tips:

1. Check the sealing strip for large cracks and cracks. It is assumed that the sealing strip is cracked and can be repaired with adhesive. In particular, the use of special adhesive sealing strip, it is very simple to make up the large crack strip. Of course, assuming that the sealing strip is seriously harmful or aging, it is better to replace the new sealing strip.

2. After the car owner uses car detergent to clean the door and window sealing strip, it is best to coat a layer of highly permeable protective agent, which can avoid the aging of the sealing strip and greatly protect the sealing of the sealing strip. In addition, the gap between the sealing strip is easily filled with sand and dust, resulting in corrosion. Therefore, a brush should be used to eradicate dust and other clean.

3. There is a relatively sealed part between the door and the body, and the sealing requirements are relatively strict. The cross-sectional shapes of each sealed part are different, and the door is often opened and closed. Three or four seals are often set on high-end cars, and the quadruple seal structure of the front pillar and the roof side beam is set. This multi-channel seal is usually arranged in the front door seam, in addition to the sealing function, there are sound insulation and noise reduction effect.

4. After the window glass is damaged, when the owner changes the glass, check the sealing strip for harm. Because the window is usually not restored to its original shape after repair, in addition to ensuring that the window glass can be easily pulled or lifted, it is also necessary to pay attention to the sealing of the window glass. Assuming that the gap between the glass and the glass notch is uneven, and the rubber strip is in poor contact with the glass and the glass groove, the owner can easily pull the sealing strip off by hand.

5. When changing the roof, the car owner should first apply a layer of conductive sealant on the pressing part around the roof, and then apply hem glue in the flow groove and the joints after welding. This will not only help the body seal, It can also avoid the early corrosion of the body due to water accumulation at the flanging weld.

6. Car sunroof is the fundamental equipment of most family cars. When the sunroof of the car is opened, the track of the rubber sealing strip is exposed to the air, which inevitably accumulates dust and even runs into small gravel. Long-term use may cause the sunroof to deform due to wear and block the drain holes. Therefore, it is very important to clean up the track and apply lubricating oil to the track.

Although the car sealing strip is a small part in the car body, it can ensure that the door is stable and heavy, and it can also protect the car from wind and rain, dustproof, heat insulation, and sound insulation, and has a decorative effect on the edges of the door and window gaps. When the body is oscillated and misunderstood, the sealing strip also has the effect of buffering, absorbing shock and protecting the glass. Therefore, the car protection is no small matter, any link can not be ignored.