U-shaped decorative stripThe cross-section is U-shaped, and the internal corners of the vertical sides on both sides of the cross-section of the main body are arc-shaped corners or chamfered corners. The U-shaped opening has three internal contact surfaces, which can effectively wrap the opening of the cabinet panel. The three internal contact surfaces correspond to the end surface and two surfaces of the cabinet board opening, and are directly bonded with quick-drying glue. All three sides are protected, even if the opening is uneven, it will not affect the quality of the cover and can meet the irregular requirements of the board. Anyone can use it to seal the irregular edges of the closed cabinet with high quality, thereby strictly preventing the release of moisture and formaldehyde.

Use a hand tool to cut a correspondingly shaped opening in the rear panel or side panel of the cabinet. When in use, buckle the U-shaped opening at one end of the side strap to any end face of the cabinet or board at the installation location, and use quick-drying glue to connect one end of the side strap to one end. The inner and outer surfaces of the cabinet panel opening. The bald head sticks firmly. Then fasten the edge strip along the end face of the opening until the edge strip completely covers all the end faces of the cabinet opening; at the bonded end of the edge strip, cut off the excess edge strip parts using a cutting knife, aligning both ends of the edge strip.

 U-shaped decorative stripIt can be made of soft or hard material, can be flexibly wrapped in the opening of the cabinet, and can improve the flatness of the appearance, so the cost is low.U-shaped decorative stripEasy to use, simple and fast operation, and can adapt to the harsh environment of various installation places.

 U-shaped decorative stripThe production has its own set of executive standard requirements. For manufacturers, this is the basic process and effective way to improve the quality of their products.

 U-shaped decorative stripMade of PVC resin raw materials by hot pressing. The appearance of furniture edge strips varies according to the added materials and processing methods. The surface of furniture edge banding that meets the standard should not have obvious drawing stripes, scratches, spots or black stains, and there should be furniture edge bands for decoration and beautification. Therefore, the bonding conditions are also very important reference standards. If it is not well bonded, the edge band of the furniture will not be able to achieve proper finishing conditions. Therefore, the hot melt adhesive on the back of the furniture edge belt must be firmly pasted. The edge banding is sold in the form of a roll, so the cleanliness of the furniture edge banding is very important, and too many seams are not good.